Revision Logs




View Error Classifications
Engine »
Fixed problem in the application of the self weight factor. The problem existed when the self weight (self weight factor) was ON in one load case then it was OFF in the next load case and then back on. The self weight factor can be different for every load case. Previous versions only applied the self weight in the first load case if toggeled.
Engine »
Corrected a printing error in the pile coordinates in the XML file.
Engine »
Fixed a problem with bearing locations in BENT structures. The program would not execute when the spacing of the bearing rows was variable.
Engine »
Fixed a printing error for pile set length in multiple piers. The program was reporting error in the pile length of a pier when the depth of the soil layers of any of the subsequent piers (piers on the right) was lower than the particular pile length.
Engine »
Fixed a pile batter check for old file compatability. The program was applying a wrong value of the batter in the piles when the pile batter (rise/run) was greater than 0.5.
Engine »
Corrected a printing error for "Summary of Abs Out-of-Balance forces" in the .out file. This section is a summary of the maximum out of balance forces for the entire structure and not per pier. The program was erroneously showing this section for every pier.
Engine »
Fixed a problem with user defined QZ curves. The program could not handle properly "TIP" models with custom QZ curves if these curves had negative and positive values.
Engine »
Fixed a bug with multiple pier structures. The program would not converge in some models with multiple piers due to internal memory allocation problems.
Engine »
Added the ability to print the forces in the dampers (dashpot forces) in the .out file.
Interface »
Fixed input file issue for bridge models with 10 or more piers.
Interface »
Fixed updating issue on load page for load cases that don't contain any loads, that were added immediately before an analysis is run.
Interface »
Fixed issue with load case count for retaining wall models when load cases with a positive retaining wall factor were deleted.
Interface »
Fixed soil drawing lag in 3D window for bridge models, where soil didn't always update immediately to reflect soil layer changes.
Interface »
Fixed input file writing error that wrote more than 80 character max in structure and supprop headers.
Interface »
Fixed node drawing issue on column for single column general pier models with a cantilever length of 0.0
Interface »
Fixed AASHTO labeling error on Load page editboxes, where editboxes would occassionally be mislabeled.
Interface »
Under the structure header, started writing # of bearing rows to input file if bearing spacing was variable.
Interface »
On the soil page, made the "specifying top and bottom layer properties" flag a layer specific flag, instead of applying globally to all soilsets in the model.
Interface »
Fixed bug with pile cap elevation and soil depth where pile length from one pier would cause analysis not to run if pile's tip elevation is deeper than the soil depth for another pier.
Interface »
For a bearing condition of "Pin", changed to release for rotation about Z axis.
Interface »
On Custom Bearing Connection Dialog, changed the bearing choice "Custom" to "User Defined"
Interface »
Added colored background to changed bearing conditions on bearing connection dialog for easier use.
Interface »
Added Pile Set and Soil Set labeling in Soil Edit Window.